I just got my car going with an nvram chip and tuner pro 5. However, when I went for my first drive, I noticed the gauge on the dashboard in tuner pro stayed at 100kpa and on the ve and ignition table, the trace went up and down with the revs, but only traced up and down the 20kpa colunm, it didnt move across? So i've got my guage reading 100 and the table trace saying 20kpa, and a car that ran relatively well and the wideband read fairly well also, hovering around 14-14.7:1 on idle, dipping to about 12:1 underload and hovering around 14.7:1 wilst cruising.
Any ideas would be greatly appreciated.
Cheers
MAP value not reading on dash board or tracing on the tables
- VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 2:54 pm
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
- Contact:
Re: MAP value not reading on dash board or tracing on the ta
Post the xdl file and what adx and xdf you are using.
Without knowing any of that, it sounds like bubble tracing is not setup on the tables or there is a map issue.
Without knowing any of that, it sounds like bubble tracing is not setup on the tables or there is a map issue.
Re: MAP value not reading on dash board or tracing on the ta
The xdf is ose12pv111 and the adx is vr_$12_v1.03 tp5.
Re: MAP value not reading on dash board or tracing on the ta
Might be best to use the adx ftom the 12P zip file.
Re: MAP value not reading on dash board or tracing on the ta
Yeah it was the adx file. I swapped it for the petrol with ve call from the zip file and it now works a treat!