pcmhacking.net

Posted: **Thu Apr 23, 2015 5:12 pm**

Can it be said that using the peak MGC at x amount of RPM can somewhat show where in the RPM band the torques falls off and where to start advancing timing again?

: screen print.jpg (184.11 KiB) Viewed 1920 times

In majority of my logs my MGC will always fall off around the 4500-4600 mark.
Could you say that this is where peak fill occurs and therefore will not make much if any torque past this point, and at that point the ADVANCE can start creeping back in?

Posted: **Thu Apr 23, 2015 5:53 pm**

Yeah I experimented with this a while ago & yeah where you find peak MGC try taking timing out & see if it increases or decreases & that should theoretically be MBT & then continue for all other areas!

Posted: **Sun Apr 26, 2015 6:46 pm**

Thnak you VX L67. will try using this method

pcmhacking.net

Using MAF to find peak VE

Using MAF to find peak VE

Re: Using MAF to find peak VE

Re: Using MAF to find peak VE