Page 86 of 140
Re: FX Holden Race Car Project
Posted: Sun Feb 04, 2018 2:54 pm
by Holden202T
speaking of transitions - heres another one!
- 20180204_151233_1517717704154_resized.jpg (288.99 KiB) Viewed 3418 times
Should be enough room at the back to access anything I need, particularly removing tappet cover for tappet adjustments etc
- 20180204_151256_1517717701692_resized.jpg (227 KiB) Viewed 3418 times
Re: FX Holden Race Car Project
Posted: Sun Feb 04, 2018 4:33 pm
by Charlescrown
Now the artwork begins blending that last panel to a flat floor pan.
Re: FX Holden Race Car Project
Posted: Sun Feb 04, 2018 6:22 pm
by immortality
Card board template time.
Re: FX Holden Race Car Project
Posted: Mon Feb 05, 2018 6:08 am
by heff0018
You can also use paper to ‘map’ the change between shapes and mark where you need to shrink or stretch. If the paper folds then you need to shrink if you need to cut the paper then you need to stretch. Easier said than done though. I seen a guy on YouTube use this technique to make simple rear guards out of sheet steel.
Re: FX Holden Race Car Project
Posted: Mon Feb 05, 2018 10:08 am
by Holden202T
CAD template = Cardboard Aided Design
Re: FX Holden Race Car Project
Posted: Mon Feb 05, 2018 10:15 am
by immortality
Holden202T wrote:CAD template = Cardboard Aided Design
Re: FX Holden Race Car Project
Posted: Mon Feb 05, 2018 4:00 pm
by Charlescrown
The pentagon transmission tunnel. Fully agree with the cardboard till it's right. This car is getting to me. I had a dream about it.
Re: FX Holden Race Car Project
Posted: Mon Feb 05, 2018 5:00 pm
by psyolent
uh uh. someones been watching project binky. cardboard aided design.
Re: FX Holden Race Car Project
Posted: Tue Feb 06, 2018 12:43 am
by vlt304
1 cool build man i take my hat off to ya. that top part of the tunnel would be awesome if it was removable to get access to the top bell housing bolts and rear head studs/ manifold bolts.
Re: FX Holden Race Car Project
Posted: Wed Feb 07, 2018 8:01 pm
by Holden202T
Getting to you Charlescrown, is that good or bad ??
Bell housing bolts will be accessible with long extension over the top of trans!