Pull up resistor removal
-
jezza351
- Posts: 116
- Joined: Fri May 22, 2009 8:49 am
- cars: vr ss comodooree
Pull up resistor removal
Hi guys , probably a silly question but I'm at the stage of modding the pcm for real time with nvram and removing the 1k pull up resistor for the wideband, in instructions it says to just remove the resistor , do I also bridge the the spots on the board with solder to link them back up or just remove and leave the board as it is ?
-
Dylan
- Posts: 3364
- Joined: Mon Aug 02, 2010 8:35 am
- cars: VR Commodore V8
Re: Pull up resistor removal
Just remove it. Also note if you had any offsets in your cal they will need adjusting afterwards.
-
jezza351
- Posts: 116
- Joined: Fri May 22, 2009 8:49 am
- cars: vr ss comodooree
Re: Pull up resistor removal
cheers DylanDylan wrote:Just remove it. Also note if you had any offsets in your cal they will need adjusting afterwards.