pcmhacking.net

no its just a stock VR V6 cam sensor setup.

Possibly different. I know the V8's running low res mode have a 4X crank trigger and a 1X cam from the dissy and the cam signal is half cam rotation looking at the chopper wheel on them.

Here is a 4.3 V6 low res crank and cam pattern look like.
Here is the V8 low res crank and cam pattern.

Thanks haven't got the V8 one too have you?

Found picture of OEM V6 Low res crank sensor.
This is the 24x conversion sensor wheel
now if I can make it fit a V6 balancer.

here is the 24x sensor wheel to degrees.

There's a model can't remember the name of V6 with the 0411 and it takes the 18X 3X crank and 1X cam. I'll see if I kept the link or maybe you're onto it all ready. Haven't followed the V6 to much so looked over it quickly.

I haven't seen a V6 using 18x 3x and 1x cam on a 411 from the factory.
that's not to say they don't exist.

Fair chance I misread it. Would of been in the 1998 2002 era if it was.
Whats your plans anyway convert a V6 of yours to to the 0411? Once you have the trigger pattern sorted it's just like any other conversion.

well my plan is to try and run a V6 with ls1 coils and 411 pcm with auto.
then later on add 3 bar mafless tune.
I want to do it with out opening and modding the pcm.

Sounds good keep us posted. Those low res trace pictures you posted. Do you have the whole manual for those models or just those images? Any chance you could PM a copy if you do?