L67 enhanced 2bar map

[Wade]

Has anyone set up a 2bar map sensor with enhanced code? Ive got a 2bar map sensor sitting here and would be good to be able to remove the boost gauge and monitor and data log boost

[immortality]

Yep. Use one of the spare input pins ( A5 or B10 ) and then modify the ADX, the calculation is in one of the other threads about data logging. Sorry, on my mobile atm so a bit difficult to search for the other thread.

[0081]

Yep i use one so.

You can pretty much run any 0-5v sensor you just need to set up the ADX so it desplays the data you want

[Wade]

Ok I’ve copied the calcs over from the vs enhanced adx I found on here. How do I go about changing the history tables. I’m not using a left hand o2 sensor, so was thinking I could use one of those.

[Wade]

Also going off the picture pin a to iat temp ground, pin b to pin a5. What’s a good pin on the pcm for the 5volt reference

[The1]

if your wiring it to B10 or A5 then you can rename and change the calc of that item to match.

[Wade]

WADE VY_V6_SC_$07_Enhanced_v1.3e WB-MAP.adx

ok I think ive got the adx sorted. found the calc for 2bar to psi and also copied the map ve and spark ve over.

[0081]

What do you mean copied the map ve and ve spark over?

[Wade]

Will generate a map based map for both map ve fueling and map spark tables when data logging as well as logging boost in psi across the range

[Wade]

Load it up and have a look at the history tables. Will find out if it all works soon