Page 1 of 1
Issues connecting with usb link 2 j2534
Posted: Thu Dec 19, 2019 12:04 pm
by the_hermie
Hello, I am trying to connect to my 02 sierra via PCM hammer with a usb link 2 and I get the following message in the debug log.
Re: Issues connecting with usb link 2 j2534
Posted: Thu Dec 19, 2019 12:08 pm
by TE27Levin
Try updating its firmware and device driver.
Re: Issues connecting with usb link 2 j2534
Posted: Thu Dec 19, 2019 1:00 pm
by the_hermie
I just updated to the latest driver and firmware and am still receiving the same message
Re: Issues connecting with usb link 2 j2534
Posted: Thu Dec 19, 2019 2:37 pm
by antus
It just says failed to set protocol. I think your interface does not support VPW.
Re: Issues connecting with usb link 2 j2534
Posted: Thu Dec 19, 2019 6:17 pm
by Tazzi
the_hermie wrote:I just updated to the latest driver and firmware and am still receiving the same message
The only reason a J2534 scantool cannot connect to a protocol is if its not supported.
Its on my todo list to read out all supported protocols from the J2534 device to indicate whats supported.
Re: Issues connecting with usb link 2 j2534
Posted: Thu Dec 19, 2019 11:24 pm
by the_hermie
I just checked Nexiq's website, the usb link 2 supports j1850 but not j1850 vpw, antus was right on.