Issues connecting with usb link 2 j2534
-
the_hermie
- Posts: 3
- Joined: Thu Dec 19, 2019 1:52 am
- cars: 2002 GMC Sierra- daily
Issues connecting with usb link 2 j2534
Hello, I am trying to connect to my 02 sierra via PCM hammer with a usb link 2 and I get the following message in the debug log.
You do not have the required permissions to view the files attached to this post.
-
TE27Levin
- Posts: 39
- Joined: Mon Dec 02, 2019 6:26 pm
- cars: 04 escalade
Re: Issues connecting with usb link 2 j2534
Try updating its firmware and device driver.
-
the_hermie
- Posts: 3
- Joined: Thu Dec 19, 2019 1:52 am
- cars: 2002 GMC Sierra- daily
Re: Issues connecting with usb link 2 j2534
I just updated to the latest driver and firmware and am still receiving the same message
-
antus
- Site Admin
- Posts: 10096
- Joined: Sat Feb 28, 2009 10:34 am
- cars: TX Gemini 2L Twincam 8psi
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B
Subaru WRX 2007
Re: Issues connecting with usb link 2 j2534
It just says failed to set protocol. I think your interface does not support VPW.
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
-
Tazzi
- Posts: 3627
- Joined: Thu May 17, 2012 10:53 am
- cars: VE SS Ute
- Location: WA
Re: Issues connecting with usb link 2 j2534
The only reason a J2534 scantool cannot connect to a protocol is if its not supported.the_hermie wrote:I just updated to the latest driver and firmware and am still receiving the same message
Its on my todo list to read out all supported protocols from the J2534 device to indicate whats supported.
Your Local Aussie Reverse Engineer
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726
-
the_hermie
- Posts: 3
- Joined: Thu Dec 19, 2019 1:52 am
- cars: 2002 GMC Sierra- daily
Re: Issues connecting with usb link 2 j2534
I just checked Nexiq's website, the usb link 2 supports j1850 but not j1850 vpw, antus was right on.