wanted 4160e bell housing

srtm racing · Post by **srtm racing** » Sat Mar 28, 2020 2:50 am

looking for 4160e bell housing or front 4 inches of damaged housing to use as template to redill 308 to 304 bolt pattern adelaide

In-Tech · Post by **In-Tech** » Sat Mar 28, 2020 2:54 am

I have an extra one from an LS engine. Is that what you are looking for? I use them as a jig to line up the oil pan during assembly.

srtm racing · Post by **srtm racing** » Sat Mar 28, 2020 3:18 am

awsome new i contacted the right people it should be single use to jig up and redrill do you want to sell or rent im happy either way.are you in adelaide ? also ill post when removed trimatic/racematic stage 2 2500 b & m stall and shifter brackets for trimatic about 2000 km if you know anyone thanks

In-Tech · Post by **In-Tech** » Sat Mar 28, 2020 4:11 am

Aww, sorry, I'm in Fresno, CA so the freight would be high. I bought one on ebay and ran out of time before it showed up so I went over to my buds trans shop to borrow one. He GAVE me one

He had quite a few bellhousings from exploded cases so you might check a trans shop and see if they have one cheap or free or rent.

srtm racing · Post by **srtm racing** » Sat Mar 28, 2020 5:18 am

hey if you can tell me the weight and i can calculate the cost to see if viable if you are still open to me getting it from you

immortality · Post by **immortality** » Sat Mar 28, 2020 6:06 am

It's not as simple as re-drilling the block. See

Image borrowed from http://www.gmh-torana.com.au/forums/top ... rns-start/

In-Tech · Post by **In-Tech** » Sat Mar 28, 2020 6:57 am

I still have the box the ebay one came in so I'll see what it says for weight tomorrow. Midnight here is Calif

Post by **delcowizzid** » Sat Mar 28, 2020 10:38 am

immortality wrote:It's not as simple as re-drilling the block. See

Image borrowed from http://www.gmh-torana.com.au/forums/top ... rns-start/

Yeah you have to fill the holes with bolts stake them in and redrill half a hole off centre. The only proper way to do it if you don't have a jig is in a mill with dro and mapping the locations on a chev pattern block in relation to the crank centreline and do the same positions on the 308 block. Takes way less than a mm off to just destroy any box you bolt behind it

In-Tech · Post by **In-Tech** » Sat Mar 28, 2020 8:57 pm

The box it came in is 20in x 20in x10in and was 14lbs.

Comcal76 · Post by **Comcal76** » Sat Mar 28, 2020 10:50 pm

You could buy a adaptor plate.

https://www.ebay.com.au/itm/Adaptor-Kit ... 1166632951

wanted 4160e bell housing

wanted 4160e bell housing

Re: wanted 4160e bell housing

Re: wanted 4160e bell housing

Re: wanted 4160e bell housing

Re: wanted 4160e bell housing

Re: wanted 4160e bell housing

Re: wanted 4160e bell housing

Re: wanted 4160e bell housing

Re: wanted 4160e bell housing

Re: wanted 4160e bell housing