i've searched and read till it's all a big blur, i have a 2000 silverado with 5.3 and 4l60 i have pulled the .bin but the OS is 9381344 which apparently is impossible to find a .xdf for so i can read it in tunerpro.
i was told i could write over and change the OS but i don't know which one would be a good match so i am confused as hell..
could someone please kinda nudge me in the somewhat correct direction?
i recently installed a "sloppy stage 2" cam and would like to attempt to tune a bit. i also need to turn off VAT and pin in the electric fans.
eventually if i don't grenade the thing during the learning i will finish fabbing up the turbo setup and tune that also.
a bit of help please
Re: a bit of help please
This wiki page should answer 99% of questions about operating systems:
https://github.com/LegacyNsfw/PcmHacks/ ... ng-Systems
https://github.com/LegacyNsfw/PcmHacks/ ... ng-Systems
Please don't PM me with technical questions - start a thread instead, and send me a link to it. That way I can answer in public, and help other people who have the same question. Thanks!
Re: a bit of help please
But, if your car is forced induction, we don't really have anything yet.
If you're willing to be a guinea pig, there are some people with ideas about how we might be able to make forced induction work with minor changes to a factory OS. But as far as I know it hasn't been tried yet. Or if it's been tried, it hasn't been documented, so there's no recipe to follow, at least not yet.
If you're willing to be a guinea pig, there are some people with ideas about how we might be able to make forced induction work with minor changes to a factory OS. But as far as I know it hasn't been tried yet. Or if it's been tried, it hasn't been documented, so there's no recipe to follow, at least not yet.
Please don't PM me with technical questions - start a thread instead, and send me a link to it. That way I can answer in public, and help other people who have the same question. Thanks!
Re: a bit of help please
Hold on. I forgot I had two different PCMs. I posted the wrong info for the os and hardware.
It’s this pcm I need the xdf and info on. No blown modded engine etc. just trying to make it clean and work. While learning a new skill.
Vin#1GKEK13Z83R160485
Os id- 12593058
Cal I’d- 12579403
Hardware id- 12570558
Serial number- 2CC1D90H2287
Broad cast code- YCTJ
Thanks for the help and the response time is incredible here. I hope to learn enough to be a help around here in time. Good day.
It’s this pcm I need the xdf and info on. No blown modded engine etc. just trying to make it clean and work. While learning a new skill.
Vin#1GKEK13Z83R160485
Os id- 12593058
Cal I’d- 12579403
Hardware id- 12570558
Serial number- 2CC1D90H2287
Broad cast code- YCTJ
Thanks for the help and the response time is incredible here. I hope to learn enough to be a help around here in time. Good day.