pcmhacking.net

Hi everyone , I have a 304 running a haltech vms .
I'm looking to change it to sequential coil on plug .

I'm running an msd flying magnet trigger wheel currently through a hi6r box .
I know I can use a vt distributor for cam reference , but could I remove all teeth bar one in the pre vt distributor and reference that for cylinder 1 ?

Cheers guys

Can't see any reason why not if you are using another signal as your primary timing reference like the MSD trigger wheel.

I'll give it a go , whats the worst that can happen haha

most cam signals only require a single tooth so it should be fine!