Page 1 of 3
Guessing plugs on loom
Posted: Sat Feb 26, 2022 8:57 pm
by GH1176
I picked up a VP engine loom, and as I didn’t get to be the one that removed it I have been guessing which plug go’s where.
I’m down to three, one of which has the same plug as a injector.
Re: Guessing plugs on loom
Posted: Sat Feb 26, 2022 9:46 pm
by GH1176
This is the plug
Re: Guessing plugs on loom
Posted: Sat Feb 26, 2022 9:47 pm
by GH1176
And the other two single green wires.
Re: Guessing plugs on loom
Posted: Sun Feb 27, 2022 7:23 am
by Gareth
Assuming it’s a V8 loom, the injector type connector should be ignition coil, the green wire with the female barrel connector is the A/C compressor, the green wire with the female blade is temp sender.
Re: Guessing plugs on loom
Posted: Sun Feb 27, 2022 9:47 am
by GH1176
It’s a V6 loom.
Re: Guessing plugs on loom
Posted: Sun Feb 27, 2022 10:34 am
by GH1176
With injector looking plug the white wire is going here to the 6 pin control plug.
Re: Guessing plugs on loom
Posted: Sun Feb 27, 2022 10:35 am
by GH1176
And the brown wire is going here to the 8 pin control plug.
Re: Guessing plugs on loom
Posted: Sun Feb 27, 2022 11:19 am
by GH1176
After stripping more back I found a extra Tacho signal wire which was hidden in the tape.
Re: Guessing plugs on loom
Posted: Sun Feb 27, 2022 11:29 am
by Dylan
Where did you get those documents from?
I'd love to get a hold of them
Re: Guessing plugs on loom
Posted: Sun Feb 27, 2022 11:58 am
by GH1176
Dylan wrote:Where did you get those documents from?
I'd love to get a hold of them
All off this forum mate.