Help with converting .bin to assembly
-
darkman5001
- Posts: 275
- Joined: Fri Dec 17, 2021 10:15 pm
- cars: 2005 Yukon, 2004 Suburban, 2001 Tahoe, 2002 Envoy, 2006 Envoy, 2003 Lincoln LS
- Location: New Jersey, USA
Help with converting .bin to assembly
I have been trying to figure out how to change a bin back into assembly language. I have been playing around with IDA Pro and Visual Studios 2022 and even MCU Xpresso IDE by NXP and have not been successful. My main focus is on the P10 and the P12 PCM flash bins. Any help would be greatly appreciated.
-
ironduke
- Posts: 820
- Joined: Thu Feb 13, 2020 1:32 pm
- cars: Mainly GM trucks, a Cruze and an Equinox for dailys..
Re: Help with converting .bin to assembly
Can't really help but just making sure you saw this.. Not your ecm but should help
viewtopic.php?f=42&t=7920
viewtopic.php?f=42&t=7920
-
antus
- Site Admin
- Posts: 10014
- Joined: Sat Feb 28, 2009 10:34 am
- cars: TX Gemini 2L Twincam 8psi
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B
Subaru WRX 2007
Re: Help with converting .bin to assembly
P10 and P12 are effectively the same as P01/P59 for purposes of reverse engineering. Only some of the hardware addresses had to be changed to make the P01/P59 kernel run on that platform for pcmhammer. Same CPU type, instruction set though.
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
-
darkman5001
- Posts: 275
- Joined: Fri Dec 17, 2021 10:15 pm
- cars: 2005 Yukon, 2004 Suburban, 2001 Tahoe, 2002 Envoy, 2006 Envoy, 2003 Lincoln LS
- Location: New Jersey, USA
Re: Help with converting .bin to assembly
ironduke wrote:Can't really help but just making sure you saw this.. Not your ecm but should help
viewtopic.php?f=42&t=7920
Thanks Ironduke. Didn't see this. Tried it and made great progress. Thanks.