In a bit of a delima. I started installing an alarm in my VR V8 BT1 auto only to find out the diagrams I have for ECU pinout arn't the same as my car.
I can only assume the fact that the ECU is shielded they also swapped some of the wiring around.
Does anyone out there have the correct wiring diagram.
Thanks
VR BT1 ECU pinout
-
Charlescrown
- Posts: 1954
- Joined: Sat Aug 06, 2011 7:58 am
- cars: V8 VR Commodore BT1
LB Lancer 2L turbo & Delco
Starion TBI with Delco
Mitsubishi Lancer EVO4 track car
NA MX5
3 vintage motor bikes - Location: Padstow NSW
-
Charlescrown
- Posts: 1954
- Joined: Sat Aug 06, 2011 7:58 am
- cars: V8 VR Commodore BT1
LB Lancer 2L turbo & Delco
Starion TBI with Delco
Mitsubishi Lancer EVO4 track car
NA MX5
3 vintage motor bikes - Location: Padstow NSW
Re: VR BT1 ECU pinout
Found one. The one I had was from a Gregory's manual. They should have stuck to street directories.