Turned it on to read it again... System Supplier ID : N/A System Name or Engine Type : N/A End Model Part No : 12636004 Supplier ECU hardware number : 12601203 Boot software part number : 12605900 Boot software Alpha Code : NA Software module 1 ident : 12635863 Software module 1 ident Alpha Code : A...

From the E38. It was random until I flashed with SPS and now it is 9999988888. Is this something to do with the other modules in the car? VIN : 1G1YV2DW9A5107899 System Supplier ID : N/A System Name or Engine Type : N/A End Model Part No : 12636004 Supplier ECU hardware number : 12601203 Boot softwa...

Any idea what this is? Ulink-nt has it listed, not sure what it is for.

Working on a BCM Hammer for flashing BCMs. Goal is to allow folks to add factory options and keep the BCM happy. Adding key fobs and power locks, etc... Currently there isn't a good away to do this. SPS can flash stuff but you have to use a different VIN number. My dev guy isn't super interested but...

Brian_Griffin wrote: ↑Sat Feb 01, 2025 4:29 pm https://www.gearhead-efi.com/Fuel-Injec ... -Bin-Files

Thanks, not much look finding a 2010 vette or camaro bin. I found a 10 truck and van, also a 2009 vette.

I tried there, it only shows 3 bins. https://tunerpro.net/download/bins/GM/

Looks like you saw the thread over there. IDK not maybe I broke the u-link. I think there is a self test I need to try to confirm. Reading that e38 should be easy verse these 3d print pogo pins jig. My dev guy is going to work on BCM hammer tonight so I'll be playing around with stuff with him. I se...

Where is the best place to look for them? I am not having much luck finding them.

I have the cables short now. Still no dice "http://www.usbjtag.com/phpbb3 ffffh,ffffh" Still waiting to get approved to that forum. With the short cables it goes right in to BDM on now. I even tried to read a good intel p59, no luck.


The pinout I am using

You do need 12v for write. But it should ID and read without it. Check your connections, keep your cables short, check you ulink config and make sure it can ID and then read a valid bin before attempting write. I am thinking maybe the cable length maybe my current issue. I used some IPC wires (seri...