i had a exp2023+ device on my desk that come with some stuff but since i dont have a cd/dvd reader in my computers any more never used it to read software. bit of googling and got the software, it worked and i now have it flashed to a good source again.. not that it bothered me im about to pick up a...

Thread dig, I've been playing around with a pim today and mapped out where & what values are used for all the settings. Got cocky and blanked the chip to try a write 1 of the files i pulled off... & it fails. Using a willem GQ-4x. Tried a bunch of different versions of 93C46. chip itself is ...

ive taken a look at 12609099 vs what my corvette runs in 12653249. The 0x1FEDEC address mentioned above is the switch to turn on the HWIO input, which i have defined as BTU0018. Now the corvette shows oil temp on the dash, so it could be calculated too. The manual gearbox runs a trans cooler too wit...

So i paid for a download of the GMW3119 PPEI 2.5 document the other day & spent a few hours going through it tonight as i wasn't having any luck trying to find some of the early CAN ID's. Turbokid provided a couple but since the VZ is a bastardized setup being from Australia and all, he did not ...

did u end up getting this solved, what is your actual problem? Is it just the PRNDL not being indicated correctly?

I will probably be tackling this problem on the car i mentioned previously as I think i have the can stuff understood & covered now.

so couldnt be stuffed working on the vz before i fly out for work tomorrow but i did put in an old e38 with the vz's base tune into my vy ute which runs a later ecu os & 2011 tcm os.. tried playing around with editing the tcm os rx/tx settings to match the early 09 os settings im using in the vz...

ooh shes rowdy, could have thrown a 4th gear pull while you were there :D It's dumped at the extractors, 2 man job to put the exhaust back on, but i also need to change out the engine mounts as they have collapsed. Have a car to tune tomorrow, so if i get that done early enough I might be able to g...

Tailshaft is in, i pulled the engine harness and removed all the old trans plug, neutral safety switch wiring & T42 controller. Wired in the tapshift tonight, got it working on 2 x TCM oses, what i wasn't expecting was the dash showing every gear it was in. Youtube video [youtube]https://youtu.b...

so did some quick testing on the vz 6 speed conversion car. i keep both engine & trans to 478 pulses per km. in efilive thats H0105 (this is basically worked out diff gear/tyre size) In scanner both ecu/tcm show same KPH. but dash needed adjusting, which is also done in the ecu, because it's put...

I had to go looking through my files as i have been playing and broke the comms. lol. ecu stays the same. I just made changes to the RX device index to remove all the modules that don't exist when i copied the corvette system segment over. Again matched the original T42, since the vet segment seems ...