What would be interesting is if we can get a hold of a calibration file for it & if we could adjust what it needs to recieve/transmit on the main canbus. Just about every late model ecu would transmit the main engine parameters. Wheel speed data would come from the EBCM, but if you have another...

sweet thanks Tazzi, and its in line with what im seeing below :D so i probed the steering wheel angle sensor tonight and got this from it. IN ts: 396124546 id: 1E5 l: 8 data: 44 00 59 10 95 00 01 7E IN ts: 396124562 id: 1E5 l: 8 data: 44 00 70 30 91 00 01 B1 IN ts: 396124562 id: 1E5 l: 8 data: 44 0...

Hptuners has a larger following because they did a much better push into the US market by providing a cheaper and imo inferior cable. Which is why theres a bunch of hacked & knock off version. Still havent seen a cloned efilive unit.. The software was often more prone to bricking controllers bec...

148 = Power Steering Indication On -Start bit 0, Length 1
& Steering Assist Reduced Indication On - Start Bit 1, Length 1

778 = DTC Triggered

well unless you know how to find the parameters in the ecu. you would be better off just purchasing efilive of hptuners.

Going into the code is not really a beginners thing if your looking to get a project up and running relatively quickly.

I reckon a lot would transfer over to the late colorado steering rack too.

ok, i suspect there is clearly a checksum going on. today instead of changing multiple options i just changed 1 value at a time and read the binary out. 4x05 is the checksum value VZ-PIM-Code.PNG See the xlsx file & zip containing read pim data. Anyone got a clue as to working out the checksum? ...

You might be correct. a few of my reads did have data in there, then it went back to zero.

since this in a vy & im not doing any linking it might have reset when it took me a few goes at recovering the bin.

the willem reads the data bitflipped but the ezp device reads it direct.

Sneak peak of what i'll finish off & then upload the xl file here again.

I'm hoping that there is a specific value that will enable the reverse relay output on the pim without setting it to a 5l40e.

i had a exp2023+ device on my desk that come with some stuff but since i dont have a cd/dvd reader in my computers any more never used it to read software. bit of googling and got the software, it worked and i now have it flashed to a good source again.. not that it bothered me im about to pick up a...