just a few observations- this new BLCD has 1250.05 as the speed sensor constant, which is VN spec. the BLCD cal in the package should really have 6248.14.
also, once you correctly subtract the table bias to tip in bump spark in the $12 xdf, the stock BLCD already had the correct table to begin with, in your cal, its 30 degrees too high.
$12P BLCD V6
-
Jayme
- Posts: 2585
- Joined: Sat Feb 28, 2009 10:59 pm
- Location: North Coast, NSW
-
VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 4:54 am
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
Re: $12P BLCD V6
All fixed in the 12P package.
-
ToyHicko
- Posts: 226
- Joined: Tue May 19, 2009 9:51 am
- cars: Toyota Celica/VN Bash Car
- Location: Coffs Harbour, Australia
Re: $12P BLCD V6
oops 
I'm sorry still learning, didn't realise the xdf file was so far out. But after a closer look I agree with you jayme over the "Tip-In Bump - Tip-In Bump spark Vs TPS & RPM (Subtract Table Bias)" the xdf file was incorrect and the orginal one was correct in that regard. Haven't upload the new table into the ecu yet to test.
I'm sorry still learning, didn't realise the xdf file was so far out. But after a closer look I agree with you jayme over the "Tip-In Bump - Tip-In Bump spark Vs TPS & RPM (Subtract Table Bias)" the xdf file was incorrect and the orginal one was correct in that regard. Haven't upload the new table into the ecu yet to test.-
VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 4:54 am
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
Re: $12P BLCD V6
If your running an auto trans the table will do nothing 