JAYCAR Speedo Corrector old model

vp304 · Post by **vp304** » Sat Aug 28, 2021 12:17 am

It works yehhhhhhh
For anyone else the instructions above are what you need to calibrate it

Post by **antus** » Sat Aug 28, 2021 2:01 am

It sounds like your sorted

It looks like these are from a later revision of the same thing. Jumpers appear to be the same at a glance.

Ive added a link to this thread to the FAQ, and I also have these scanned docs I'll attach here for more detail incase they're ever useful to anyone.

Post by **delcowizzid** » Sat Aug 28, 2021 7:59 am

Good stuff guys

vp304 · Post by **vp304** » Sat Aug 28, 2021 9:00 am

Good stuff thanks antus
Antus is that the newer version of the speedo corrector that people say they have trouble with on vn to vs commodores?

Post by **The1** » Sat Aug 28, 2021 11:33 pm

someone sent these to me, i havn't looked at them but might be worth investigating, they have a few different methods and types.

https://www.dakotadigital.com/index.cfm ... /prd57.htm
https://www.dakotadigital.com/index.cfm ... prd916.htm

ejukated · Post by **ejukated** » Sun Sep 05, 2021 7:37 am

From memory the original design was from a Silicon Chip magazine, you could probably find the calibration procedure in there too

Post by **Holden202T** » Mon Sep 06, 2021 12:13 am

Page 65

Silicon_Chip_Magazine_2006-12_Dec.pdf

Post by **Holden202T** » Wed Oct 06, 2021 12:19 am

After reading this thread and finding the silicon chip article with all the info in it i decided to put together a PCB from it and see if i could get it to work.

so this is basically the jaycar speedo corrector mk2 i believe but condensed onto a smaller double sided PCB to fit into a case that i had previously used for another project, and draw up a pcb shape to fit it.

MicrosoftTeams-image.jpg

so below, the top trace is the signal from an arduino (5v quare wave) being fed into the speedo correctors input wire, and then the one below it is the signal out of the unit.

243277896_541953917102239_2148527982749002974_n.png

Theres a few things i found like part ID's and such that were not right on the PCB and in particular the transistor footprint has two tenths of fuck all gap between the solder pads, so i will update them for future boards, but other than that it works

i also managed to find the firmware for the PIC on silicon chips website so the entire process can be replicated!

VX L67 Getrag · Post by **VX L67 Getrag** » Wed Oct 06, 2021 1:59 am

AWESOME WORK!!!! you clever cookie!

immortality · Post by **immortality** » Wed Oct 06, 2021 2:05 am

That's bloody brilliant. Any chance it can also do signal conversion for those who are doing T5 transmission swaps with ecotecs/L67's?

JAYCAR Speedo Corrector old model

Re: JAYCAR Speedo Corrector old model

Re: JAYCAR Speedo Corrector old model

Re: JAYCAR Speedo Corrector old model

Re: JAYCAR Speedo Corrector old model

Re: JAYCAR Speedo Corrector old model

Re: JAYCAR Speedo Corrector old model

Re: JAYCAR Speedo Corrector old model

Re: JAYCAR Speedo Corrector old model

Re: JAYCAR Speedo Corrector old model

Re: JAYCAR Speedo Corrector old model