raptored VY!

[drippy]

bin is on page 1,

what adx are you using to read it? as mine doesnt show how much knock retard it is pulling?

[The1]

bin looks fine for spark maps, bit strange saying it's pulling that much timing, it's following your tps as well, yeh im using the adx out of the same zip you are. I have other logs that play fine

[drippy]

yeh i have pulled a heap of timing out of them spark maps, my base line i used was the standard supercharged maps.

is there a better adx file to use?

the standard supercharged spark maps seemed to go well driving wise, this map feels sluggish.

[The1]

the adx is fine with my other logs and is the only one i know of, could be a wiring fault or bad knock sensors? do you have any logs before it went on?

[drippy]

i dont have any other logs before it went on,
but i can swap belts over and log it without the charger! ill do that tomorrow i think

all tho i did have a look at one of the other adx's from https://pcmhacking.net/forums/view ... f=10&t=725

and that showed only a tiny amount of knock showing only 1 degree in 2 spots looking through that log yet it didnt show history graphs only wideband ones.

[VL400]

That flash PCM ADX should be correct, it is the more recent of them and is known to work with current versions of TP. The other one in the zip does not look like it has the right data - there is no single knock retard in the data stream AFAIK.

[The1]

i can't even play his log with your adx VL it's just blank , yet it plays fine in the other VY adx but with the issue we were talking about.

[drippy]

i ran a log using VL's adx and it showed only a slight knock at one point
ill have to start fresh using that one logging changes as the previous one shows knock no matter how much timing i take out!

i hope it is just the adx causing my issues! dont feel like forking out more money on parts lol

[The1]

i give up on vx vy n/a lol they just dont like me.

[delcowizzid]

ide repin the wiring to a vt ecu and start with a L67 tune