Couldnt really find a section for this..

[antus]

Hi ZerOne, and welcome aboard!

I found your doco on the VE cluster, and it looks very good. Theres no problem with having a direct link here, so i'll post it:

http://www.carmodder.com/doc-holden-com ... 57m19.html

Thanks for contributing!

[88GreenVN]

I have been following this post and got a bit lost on the page that talks about hooking up the iscp to the chip

From what I have read (please please correct me if I am wrong)
wire up the iscp - chip
pin 1-3 di
pin 2-8 vcc
pin 2-6
pin 2-7
pin 3-1
pin 4-5 gnd
pin 7-2 clk
pin 9-4 do

Looking forward to your great help.

Thanks.

[The1]

check my post page 14

[88GreenVN]

check my post page 14

Cheers - I've ordered the reader gadget and dragged out all the stuff we were playing with 2 years ago - ready for another crack at this. I'll lset you know when we make progress.

[88GreenVN]

When using PonyProg, what device are you using? I have tried 93x6 9356 and 24xxx auto ?

I am getting bus busy or hardware error

Or are you using a different program.

Thanks.

[The1]

X2444 16bit and off jumpers

[88GreenVN]

I am running v1.7 and in the device list I have no X2444 option only x24xx auto under the i2c buss eeprom

[festy]

It's been in the codebase since 2007 from memory, might be time to upgrade

[88GreenVN]

my bad... Now I can read the chip just not write to it.

All good fun!

[festy]

Is it being read correctly?
Does the bin look right?