uv eraser
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: uv eraser
mine touch the light and take no more than 6 minutes
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
Re: uv eraser
hehe touch the light
thanks for the info delcowizzid
thanks for the info delcowizzid
Re: uv eraser
its possible to fit the whole memcal in the draw with ease if you remove the middle slides under the draw and enlarge the draw opening.
you can get 2 in.
was bored...
while it was apart, cut off the dodgey international plug/adapter and added a lead
cheap, and works a treat!
you can get 2 in.
was bored...
while it was apart, cut off the dodgey international plug/adapter and added a lead
cheap, and works a treat!
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: uv eraser
haha mine has a T shaped hole in the drawer to slide memcals through
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
- Holden202T
- Posts: 10328
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: uv eraser
ditto
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread