I'm trying to log on a S2 5.0l VS statesman, if I don't have the plugin I get nothing in the drop down box, but never tried to log, let alone connect.
Im using a dell inspiron N5010 i7, running win 7.
Tunerpro RT problem
-
Holden202T
- Posts: 10394
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Tunerpro RT problem
set it up like the below, so under data aquistion & logging select to use plug-in, then in the below pull down use tunerpro interface rather than ose plugin.
- tp5 properties.jpg (72.02 KiB) Viewed 2432 times
No matter what the question is, the answer is always more horsepower! 
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Tunerpro RT problem
Ok so that's only for logging, I will have to change it back to emulate yes?
-
Holden202T
- Posts: 10394
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Tunerpro RT problem
emulation settings are on the right hand side of that screen, but if you want to log and tune realtime at the same time you need to use ose plugin to handle it all.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread