VT-VX Clusters

[antus]

You might also need to set the data size to 16 bit words.

[VX L67 Getrag]

Thanks again Ant,

I'll give it a go tomorrow!

[VX L67 Getrag]

Well here's those 2 other bin's with byte flip & lines up better with mine that the calc worked for which these 1's didn't the way they were so I assume this way is correct?

EDIT: just did the calc for odo with these new bins & these now actually work out to what there listed as, so this is obviously the correct way round.

[Vpgts076]

Firstly I Would like to say my hat comes off to you boys..... i found ths forum by mistake while doing some upgrades from level 1 to 3 cluster into a vs and now know how to program them . to be honest never was into electronics but no i am hooked.....

I would like some help in reading VT L3 clusters have read the posts but still am un sure of.......

What is the best programmer, below is a link to what i am using on my l3 vn-vs clusters with aa iscp board...
http://www.ebay.com.au/itm/24Cxx-93Cxx- ... 3cc7b7667c


Does chip need to be removed???


What is the best clip to attach to the cluster or best position to attach???


What is the best software to program?

thanks

Daniel....

[VX L67 Getrag]

Yeah all the guys here are great & could rebuild the country but properly if it ever fell apart!

Not sure what model the vt clusters went to MCU type do you have a picture of the circuit board?

But yeah will need to do some unsoldering the resoldering either way!

[Vpgts076]

Hi MAte,

Yes ill open cluster tommorrow and post a picture but is there a guide.....

I.e how to tell them appart... i am also going to do at later Vx one as well....


thanks
Daniel

[VX L67 Getrag]

These are the 2 types.....

But to do VX's you need different software & programmer (NEC mcu type) VT you can just do by removing eeprom & read then write... unless there's someone out there that could do it over the BUS...

[Vpgts076]

Hi Guys,

Tiping i have the later model cluster as it has an NEC EEPROM.

IMG_4544.jpg (47.14 KiB) Viewed 4767 times

IMG_4545.jpg (48.17 KiB) Viewed 4767 times

Am i correct??

which is the best programer?

What is the best technique to lift pins?
thanks
Daniel

[kham383]

You're looking at the front of the board check the back side to see what eprom it has.

[Vpgts076]

Thank you.

Bottom has nothing except plug, cap, res & speaker....

IMG_4548.jpg (24.85 KiB) Viewed 4754 times

IMG_4547.jpg (32.66 KiB) Viewed 4754 times

Thoughts?