Converting 202 to ABS Crank Trigger

Post by **Holden202T** » Mon Jan 28, 2013 9:12 pm

got it off the net, but it wasn't rusty when i got it, i should have painted it!! has been sitting in the shed for months, i'll be taking it to my mates workshop and using his sand blaster on it though don't you worry!

VX L67 Getrag · Post by **VX L67 Getrag** » Mon Jan 28, 2013 9:25 pm

was there a part number or anything you typed into the NET to find it?

But yeah sand blaster & coat of paint might save it for a few more years!

Post by **Holden202T** » Mon Jan 28, 2013 10:06 pm

i'm not sure if this was the exact seller but you get the idea

http://stores.ebay.com.au/trigger-wheel ... 34.c0.m322

VX L67 Getrag · Post by **VX L67 Getrag** » Tue Jan 29, 2013 5:17 pm

WOW there's certainly a range of them!

Post by **Holden202T** » Tue Jan 29, 2013 5:43 pm

yeah i found the one that was going to have the notches above my balancers diameter and went with that, wish it was solid like the picture showed though, would have been easier to put holes in!

Post by **Holden202T** » Sat Mar 02, 2013 4:41 pm

well had some more progress on this, needed to finish mounting and locating the new trigger in the right spot relative to TDC etc and also needed to re-make the crank trigger bracket in the right spot so that has now all been done!

without precisely timing everything i'm thinking its going to be about 65 degrees reference angle !!

: new trigger mount 1.jpg (192.51 KiB) Viewed 6028 times

: new trigger mount 2.jpg (257.91 KiB) Viewed 6028 times

Another step closer to a dizzyless 6 coil 202

VX L67 Getrag · Post by **VX L67 Getrag** » Sat Mar 02, 2013 4:58 pm

THAT IS FRIGGEN COOL! Nice work keep us updated!

Post by **Holden202T** » Sat Mar 02, 2013 5:12 pm

will be once its running on it

VX L67 Getrag · Post by **VX L67 Getrag** » Sat Mar 02, 2013 5:23 pm

I guess that all depends on how hard you push it to how COOL it keeps!!!

monaro308 · Post by **monaro308** » Sat Mar 02, 2013 8:21 pm

Yeah thats looking good Holden202T

Hmmm a dissyless 308 red motor running 8 coils on the homemade Delco EFI

Converting 202 to ABS Crank Trigger

Re: Converting 202 to ABS Crank Trigger

Re: Converting 202 to ABS Crank Trigger

Re: Converting 202 to ABS Crank Trigger

Re: Converting 202 to ABS Crank Trigger

Re: Converting 202 to ABS Crank Trigger

Re: Converting 202 to ABS Crank Trigger

Re: Converting 202 to ABS Crank Trigger

Re: Converting 202 to ABS Crank Trigger

Re: Converting 202 to ABS Crank Trigger

Re: Converting 202 to ABS Crank Trigger