Ok newby questions! I have my new willem burner pcb 50, 0.98D5, eeprom at29c010a. I load a bin file and try to burn it to the eprom. I comes up with Error write sector 0. I have installed port95nt.exe. Jumpers are good (I think), dipswitches are good. My burner is from Darkwire. The eprom is new and blank, all FF in the buffer?
If I read the blank chip the top heading changes to AT20c010 (128) image. I can then hit program and it will write to chip, verify and ok it. But not if I load a bin.
Any suggestions would be good
![comp :comp:](./images/smilies/comp26.gif)