OSEPlugin for Tunerpro 5 v1.80

[Danielbbyy]

i am lost i cant get tunerpro to work i have folled the tunerpro setup i have the right usb serial port and plugin.dll all of that is good but when i plug the the ecu to the car and start up tunerpro it cant find the hardwaer i have both the blue leds on and when i try to initialize hardwara i get the red and yellow leds flashing but no hard ware found

[The1]

can you connect with flashtool and say download cal or bin? obviously your using a realtime bin

[Danielbbyy]

well well well if you tick cable echo it works

[Holden202T]

[Danielbbyy]

i think i have stuffed me nvram all was going good untill the last time i fitted the board i turned the ignition on and the ecu went in to limp home
i removed the nvram board from the ecu and i had bent the top left pin i have refitted my eprom and all is good so i think my ecu is good i refitted the nvram doard and
if i remove the bin sw plug it will not go into limp but eather way tuner pro will not connect

[antus]

If you are able to straighten the pin out without breaking it then the data on the nvram is probably corrupted, but the hardware itself is ok. You'll need to put the nvram in a programmer such as a gq-4x to put a stock bin back on it as a starting point that can run the ecu and get it talking again.

[Danielbbyy]

Ok the ecu is still good the pin is good and it can still run on my memcal
i think the nvram is corrupted can sumeone out there reprogram the ram fore me or do i by a nother one programed to be safe

[Holden202T]

You'd be better off buying a programmer so you can do it yourself !!

[Danielbbyy]

how much should I pay for one and where is the best place to buy 1 from ebay want a round a 120 dollars

[antus]

mcumall.com or ebay. should be between about $100 and $120.