Did a Log, do the values look ok?

bck2basic · Post by **bck2basic** » Thu Oct 24, 2013 2:47 am

Yeah that's the thing, hopefully that might make a difference to something.

Post by **Holden202T** » Thu Oct 24, 2013 3:26 am

it might take pulsations out of the fuel system but its not going to stop your car running really rich if thats what its doing.

get a decent log of it driving at running temperature for a bit and post that up!

bck2basic · Post by **bck2basic** » Thu Oct 24, 2013 5:42 am

I thought I'd get it as in pretty sure they came standard and that must have been for a reason.

Yeah I will. Not home till Sunday, so I'll put in the new sensors and get a log of a drive up and down the street as it's unregistered at the moment to get vass.

bck2basic · Post by **bck2basic** » Tue Oct 29, 2013 11:13 am

ok. ive put in a second hand oxy sensor and iat sensor, rewired both also as i had splits in the wires. can someone please have a look and tell me if everything looks ok?

also can someone shed some light on what is the factory and or most beneficial operating temp for a 304? Not what notch on the gauge it sits at but what degrees?

I have a a new genuine holden 88 deg thermostat, new cpc radiatior cap, new radiator, new hoses, new clamps, new au thermo fans and davies craig adjustable thermo switch. I have the thermos set to come on around 95 deg and off at around 90. Is this ok? Or should I put in a lower temp 82 deg thermostat and have the thermos kick in at a lower temp

thanks

bck2basic · Post by **bck2basic** » Fri Nov 01, 2013 8:39 am

Can someone please have a look? Thanks

Post by **Holden202T** » Fri Nov 01, 2013 11:13 am

looks like your O2 sensor is doing SFA!

bck2basic · Post by **bck2basic** » Sat Nov 02, 2013 2:20 am

Ok, so I should replace the Oxy sensor with a new one?

Does everything else look ok?

Thanks

Post by **delcowizzid** » Sat Nov 02, 2013 2:36 am

throttle voltage is a little high .check if you have a dampner connected to the external fuel pump bracket if you dont you may as well fit one removing them can make fuel trims go way out

bck2basic · Post by **bck2basic** » Sat Nov 02, 2013 3:59 am

Tps is like 2 months old. I have a dampner installed right near the fuel rail entry. I don't think there's a dampner near fuel pump as it's in a vl. Do I need to replace Oxy?

Post by **delcowizzid** » Sat Nov 02, 2013 5:37 am

either o2 sensor is dead or the wiring to it is .test continuity of the wire from o2 to ecu plug without the ecu plugged in.if that checks out ok fit a new sensor
also where is the sensor in the exhaust

Did a Log, do the values look ok?

Re: Did a Log, do the values look ok?

Re: Did a Log, do the values look ok?

Re: Did a Log, do the values look ok?

Re: Did a Log, do the values look ok?

Re: Did a Log, do the values look ok?

Re: Did a Log, do the values look ok?

Re: Did a Log, do the values look ok?

Re: Did a Log, do the values look ok?

Re: Did a Log, do the values look ok?

Re: Did a Log, do the values look ok?