VS Commodore 202 Drag Car :)
- Holden202T
- Posts: 10330
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: VS Commodore 202 Drag Car :)
well I've decided to screw the 202 back together bush mechanic like, and run it on the test stand to see if the knock is still there so I can determine if the T700 is fucked or not ..... its a bit rough of a setup but I have had it running for 10-15 seconds at a time and I haven't heard any knocks, so im starting to wonder if its transmission or converter related!
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
- Holden202T
- Posts: 10330
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: VS Commodore 202 Drag Car :)
Finally got some time to look into the gearbox and I think I found a possible culprit!!
This is the only issue I can find, and the picture does it justice!!! Wondering if some metal fragments have ripped through the converter fucking a bearing or similar and hense the low rpm knock ?!?!
This is the only issue I can find, and the picture does it justice!!! Wondering if some metal fragments have ripped through the converter fucking a bearing or similar and hense the low rpm knock ?!?!
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
- delcowizzid
- Posts: 5499
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: VS Commodore 202 Drag Car :)
the sprag in the convertor will most likely be smashed
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
-
- Posts: 591
- Joined: Thu Nov 03, 2011 7:57 pm
- cars: hsv enhanced vs ss
vt xu6
fb holden
toyota landcruiser
vt ss s1 - Location: perth wa
Re: VS Commodore 202 Drag Car :)
I have to agree with delcowizzard as he said a stator sprag or maybe cracked pump.
- Holden202T
- Posts: 10330
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: VS Commodore 202 Drag Car :)
Are you saying this is a result of the spline failure or the cause ??
Does this kind of failure sound like a big end knock??
Does this kind of failure sound like a big end knock??
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
- delcowizzid
- Posts: 5499
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: VS Commodore 202 Drag Car :)
all the insides of the TC will be flopping around inside it and most likely will see parts go past the hole in the TC when you tilt it left and right its in turn worn the end of the shaft
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
- Holden202T
- Posts: 10330
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: VS Commodore 202 Drag Car :)
well this is pretty out of date hehe ... cars now running one of my extra clutched trimatics and seems to be working flawlessly now!
looks like its going to be fully delcod soon, going to be ordering the rest of the bits needed to remove the methanol 500 holley and run it back on injection (its already spark controlled by delco) so should make it nicer to start on cold mornings!
theres also been some talk of putting NOS onto it if funds allow! we have two months before the next Gunnedah drags so the goal is to have it at least efi'd by then ....NOS or not time will tell!
looks like its going to be fully delcod soon, going to be ordering the rest of the bits needed to remove the methanol 500 holley and run it back on injection (its already spark controlled by delco) so should make it nicer to start on cold mornings!
theres also been some talk of putting NOS onto it if funds allow! we have two months before the next Gunnedah drags so the goal is to have it at least efi'd by then ....NOS or not time will tell!
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
- VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 2:54 pm
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
- Contact:
Re: VS Commodore 202 Drag Car :)
Holden202T wrote:theres also been some talk of putting NOS onto it if funds allow!
- Holden202T
- Posts: 10330
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: VS Commodore 202 Drag Car :)
well its all going ahead, NOS kit that was locally on ebay with a full bottle of gas has just been run and won stay tuned
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
- antus
- Site Admin
- Posts: 8292
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: VS Commodore 202 Drag Car :)
- Attachments
-
- nos_20logo.gif (7.82 KiB) Viewed 3845 times
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396