Trigger points for CAS.

Post by **antus** » Tue Apr 22, 2014 8:01 am

d1928a will work

GH1176 · Post by **GH1176** » Fri May 02, 2014 4:28 pm

Just started measuring out the size of the reluctor wheel needed and where the sensor will go and I worked out the height of the bracket that holds the sensor needed to be within 27-29mm off the face of the timing cover too the centre of the sensor and when I measured the side of the cover plate on my spare VY diff their the same height and as I am selling my SS I'm going too cut the sides off the diff and weld it too the timing cover then I can start planing out the trigger points.

Post by **Jayme** » Fri May 02, 2014 5:18 pm

yeah the sensor mount needs to be rock solid. ive done a few and any vibration on the sensor mount will falsely trigger the module and cause wicked backfires.

GH1176 · Post by **GH1176** » Fri May 02, 2014 5:29 pm

That's why I'm going to use the one of the diff, solid as.

GH1176 · Post by **GH1176** » Fri May 02, 2014 5:30 pm

GH1176 · Post by **GH1176** » Fri May 02, 2014 5:37 pm

I'll see how well the timing cover takes a good penetrating weld.

GH1176 · Post by **GH1176** » Fri May 02, 2014 5:40 pm

Post by **antus** » Mon May 05, 2014 9:41 pm

I think you're barking up the right tree there.

GH1176 · Post by **GH1176** » Tue May 06, 2014 5:04 pm

As I've seem too have lost both of my abs sensors and as I was looking I found one from the diff of a R33 skyline seems to be same type and might fit the commodores mount and I was wondering if anyone knows if it can be used?

Post by **festy** » Tue May 06, 2014 5:45 pm

If it has 2 wires, it will probably be fine.

Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.