Trigger points for CAS.

GH1176 · Post by **GH1176** » Tue May 06, 2014 5:54 pm

Yes two wires.

GH1176 · Post by **GH1176** » Thu May 08, 2014 12:08 pm

GH1176 · Post by **GH1176** » Thu May 08, 2014 12:09 pm

GH1176 · Post by **GH1176** » Thu May 08, 2014 12:10 pm

GH1176 · Post by **GH1176** » Thu May 08, 2014 12:13 pm

The skyline sensor fits in but the screw that holds it is out too far, but as the cable that comes with it is like 2 ft long I might make it fit and hopefully it reaches the module.

Post by **Holden202T** » Thu May 08, 2014 12:33 pm

just be careful with that, i tried using the balancer with slots in it for the trigger and it was "flakey" also they tend to spin when old!

Post by **festy** » Thu May 08, 2014 12:45 pm

You can extend the wires if needed, just use shielded cable.

GH1176 · Post by **GH1176** » Thu May 08, 2014 1:08 pm

Not using the balancer as you already told me not too, haven't made the wheel yet just spaced the gilmer pully out from the balancer and I won't weld the bracket on until the wheel is in place.

GH1176 · Post by **GH1176** » Thu May 08, 2014 1:15 pm

I was told you could use the shielded audio cable from Jarcar as I have heaps of it can it be used?

Post by **Holden202T** » Thu May 08, 2014 2:10 pm

i used shielded microphone cable from them, approx 1.5 mtrs then 20 cm lead from the sensor thats not shielded, haven't had any issues!

Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.

Re: Trigger points for CAS.