Tuning training required in victoria

A place For General Chit Chat Etc
Dylan
Posts: 3364
Joined: Mon Aug 02, 2010 6:35 pm
cars: VR Commodore V8

Re: Tuning training required in victoria

Post by Dylan »

Thought it was just my end. I could hear hardly any voices.
I've never used skype but i could see names scrolling in the top right but no voices.
0081(2)
Posts: 149
Joined: Wed Oct 31, 2012 6:59 pm
cars: VY commodore supercharged V6
Location: Sydney

Re: Tuning training required in victoria

Post by 0081(2) »

Holden202T wrote:
0081(2) wrote:I got a recording and watched it later. Gave me a bit to think about and loom forward to another one, if it happens
so if your recording has The1's voice ? are you willing to upload ?

I too couldn't make it but would be keen to watch it

Yep it does have The1's voice but it also has a bit of background noise, i left the laptop recording in another room and it didn't dawn on my it would pickup any voices while it was recording.
The worst part is at the start but even then its not that bad also one part at the end when i pick the laptop and i was talking to the other half.
When i played it back and could hear all the background noise i though crap i hope you all didn't have to listen to that, then remembered that i did mute the Skype mic. Sorry if i did stuff it and you could hear the kids crying in the background at the start


I also left the camtasia window open in the bottom right corner which slightly blocked some on the page not really a issue it only really affects it when The1 was going through the enhanced PDF. and skype blocked some in the middle of the bottom.


I only downloaded camtasia as it started and was in a bit of a rush to get it setup. I don't know if its worth while posting it but if someone wants to try and strip the audio out try and sync it to The1's recording i can pass it on.
User avatar
Tazzi
Posts: 3553
Joined: Thu May 17, 2012 8:53 pm
cars: VE SS Ute
Location: WA
Contact:

Re: Tuning training required in victoria

Post by Tazzi »

The1 wrote:im in QLD so +10

i got camtasia on, installed an older version and got another 30days and it's working so should be good.
PM sent.
Your Local Aussie Reverse Engineer
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726
Image
User avatar
The1
Posts: 4813
Joined: Mon Jan 04, 2010 10:23 am

Re: Tuning training required in victoria

Post by The1 »

0081(2) wrote:
Holden202T wrote:
0081(2) wrote:I got a recording and watched it later. Gave me a bit to think about and loom forward to another one, if it happens
so if your recording has The1's voice ? are you willing to upload ?

I too couldn't make it but would be keen to watch it

Yep it does have The1's voice but it also has a bit of background noise, i left the laptop recording in another room and it didn't dawn on my it would pickup any voices while it was recording.
The worst part is at the start but even then its not that bad also one part at the end when i pick the laptop and i was talking to the other half.
When i played it back and could hear all the background noise i though crap i hope you all didn't have to listen to that, then remembered that i did mute the Skype mic. Sorry if i did stuff it and you could hear the kids crying in the background at the start


I also left the camtasia window open in the bottom right corner which slightly blocked some on the page not really a issue it only really affects it when The1 was going through the enhanced PDF. and skype blocked some in the middle of the bottom.


I only downloaded camtasia as it started and was in a bit of a rush to get it setup. I don't know if its worth while posting it but if someone wants to try and strip the audio out try and sync it to The1's recording i can pass it on.
If you can get it up somewhere i still have my camtasia files so can sync up the audio stream.
User avatar
Holden202T
Posts: 10394
Joined: Sat Feb 28, 2009 9:05 pm
Location: Tenambit, NSW
Contact:

Re: Tuning training required in victoria

Post by Holden202T »

how bigs the file ? I have an FTP site you guys can use ?
0081(2)
Posts: 149
Joined: Wed Oct 31, 2012 6:59 pm
cars: VY commodore supercharged V6
Location: Sydney

Re: Tuning training required in victoria

Post by 0081(2) »

Its 1.35g
User avatar
Tazzi
Posts: 3553
Joined: Thu May 17, 2012 8:53 pm
cars: VE SS Ute
Location: WA
Contact:

Re: Tuning training required in victoria

Post by Tazzi »

0081(2) wrote:Its 1.35g
Might go better putting that onto a dropbox account. Then one of the guys can download it and try syncing up the audio.

Pretty sure you can strip the 'mic' noise completely and keep the 'system' noise which should The1 and everyone talking. Ill have to double check that camtasia has that ability!
Your Local Aussie Reverse Engineer
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726
Image
0081(2)
Posts: 149
Joined: Wed Oct 31, 2012 6:59 pm
cars: VY commodore supercharged V6
Location: Sydney

Re: Tuning training required in victoria

Post by 0081(2) »

Ill up load it to my drop box account then.

The1 if you want to pm me your email ill send you the link.
kojab
Posts: 445
Joined: Sun Mar 22, 2009 11:52 am
cars: VT V6 supercharged in a corolla
Location: Sydney
Contact:

Re: Tuning training required in victoria

Post by kojab »

kojab wrote:I am looking forward to the conference on Saturday as is would be an ideal time for me to introduce my 30 Hz VX/VY TP logger which will compliment Nigel’s enhanced bins.
The1 wrote:would be good to see.

I have put a 30Hz bin and adx in the “Custom Code” section of this forum for you to look at. New topic name is 30HZ logging for VX/VY flash PCMs

Let me know your thoughts

Cheers
Dick
User avatar
j_ds_au
Posts: 387
Joined: Sun Jan 25, 2015 4:21 pm
Location: Sydney

Re: Tuning training required in victoria

Post by j_ds_au »

0081(2) wrote:Its 1.35g
I think TMPGEnc and VLC can allow you to split the video and audio, so the audio could be significantly smaller.

Joe.
Post Reply