424 with dual wideband o2 sensors, is it possible???

[Jayme]

Isn't there spare analogue inputs on the ecu you can just plug into?

not sure...

nope..... direct logger input is your only option, but relatively easy to set up. I can also help with any adx mods you need done.

[Gareth]

thanks Jayme

So i'll need to get the logger wiring diagram out and consider what needs wiring prior to building the loom..

[Gareth]

Methanol: very roughly +5 degrees?

Also with the wideband cable, not sure on that type of connector but i believe the bosch units have a calibration resistor in the connector. If you change the wire or plug you may effect the readings. Decide if thats worth the risk and maybe take some baseline readings from a car in a known state (idle at x degrees temp) and repeat after modification to test for changes that may have been caused by the cable mods?

Cheers Ant, and this is what it looks like

I assume it's on the underside of that little board