Hotrod convertion

[delcowizzid]

Now that you have a comport showing use the oseflashtool to confirm you can connect its probably easier and will show why it won't connect

[cvan1939]

Thanks l will give it a go tomorrow

[cvan1939]

The Flashtool can't find hardware fails to connect. I checked the ses fault codes and the 34code came up
Not sure what 34 is but the code list that I have says it's maf low air flow

[delcowizzid]

34 is map volts low possibly due to it running badly

[Dylan]

Do you have a 12P bin loaded? Did you set the comport in flash tool and the interface type and ecu type etc?

[cvan1939]

I set comport 3 in the flashtool in the vehicle drop down there is no option for a 12p in a 165. I tried the 12p 808
tried the USB Aldl and the rs232 808 interface. I am only a newbie at this feeling my way and any advise is welcome

[cvan1939]

retried the flashtool to no avail it scans but no response no device found

[MrWillys]

retried the flashtool to no avail it scans but no response no device found

Have you downloaded and installed this driver?

http://www.ftdichip.com/Drivers/VCP.htm

[antus]

The 808 settings with the usb aldl interface are fine for this application.

[cvan1939]

Mr Willis yes I have downloaded the drivers but still can't access the ECM
Hi Antus I have tried the 808 12p and the Aldl interface settings but no go. Downloaded loaded drivers verified comport 3.
With the flashtool have tried several combinations it scans but has no response. The car runs so must have some thing in there it also flashes code.