Vlad's rides thread

[immortality]

That's probably why the Americans came out with this
http://www.taperformance.com/prodimages ... _V3800.jpg

TA_V3800.jpg (36.98 KiB) Viewed 4395 times

[immortality]

Something else I though about but have never actually measured up is fitting ecotec mains caps to a Buick block so you can at least have cross-bolted mains. The other option would be the MACE mains girdle.

[vlad01]

Something else I though about but have never actually measured up is fitting ecotec mains caps to a Buick block so you can at least have cross-bolted mains. The other option would be the MACE mains girdle.

won't work. there is like a 20m+ void between the cap and the side of the block. I wouldn't bother anyway as VR have standard issue powdered metal forged caps anyway just like the ecotec does. The side bolt do help a little but only a little as they only screw in about 4-5 threads and at a very low torque. I recall about 15 Nm

[vlad01]

That's probably why the Americans came out with this

They already use them, someone commented the same thing.

[vlad01]

More updates.

TB done, cruise control pin added and also fitted a circlip which is missing on most. I happen to have a box of them the same size

IMG_1539_zpseqdaiisz.jpg (75.63 KiB) Viewed 4395 times

Early Easter decorations.

IMG_1542_zpsoj81ejww.jpg (185.63 KiB) Viewed 4395 times

Stuff.

IMG_1543_zpszozsck9w.jpg (230.9 KiB) Viewed 4395 times

more stuff.

IMG_1544_zpsy1iazbe3.jpg (204.76 KiB) Viewed 4395 times

Decided to do the rear door jams as they were a bit chipped up and I also spilled acetone from the roof and later found it ran down the pinch welt all the way to he bottom so I said fuck it, get them painted too.

IMG_1555_zpsp2gqz6ld.jpg (209.27 KiB) Viewed 4395 times

IMG_1554_zpsazfomwh8.jpg (168.55 KiB) Viewed 4395 times

IMG_1553_zps7fyp6t1u.jpg (203.6 KiB) Viewed 4395 times

Got these off without breaking a single clip.

IMG_1556_zpsyyxsepdn.jpg (183.5 KiB) Viewed 4395 times

Can buy them? re-manufacture them.

IMG_1557_zpsniidl9y4.jpg (170.73 KiB) Viewed 4395 times

[Gareth]

What product did you use to recoat those last bits?

[vlad01]

plastidip. 3 coats of it.

black dip-able/brush-able type, not spray can like you see everywhere.

Only way to get it is via autobarn and get them to look it up via the broken catalog. Plastidip's own listings and site tell you nothing and you can't contact them, very very old couple who are tech illiterate hold the product in Australia.

[delcowizzid]

That broken block is from a gn in the states fell in half when the owner onbolted the main caps lol

[vlad01]

Must of had a bit of a noise like that lol.

[Holden202T]

That broken block is from a gn in the states fell in half when the owner onbolted the main caps lol

lol yeah I dare say the inlet manifold and main caps was about all left keeping it together!