WB setup in adx

[Wade]

can someone please help and or walk me through setting up the adx for a Spartan WB. the calc ((20.00-10.00)/255*x)+10.00. b10. ive never set up an adx, and its all mumbo jumbo to be

[The1]

assuming youve wired the analogue output to pin b10

open tunerpro, hit the edit adx button to the left of the connect button, then goto values and select Pin B10 Input, you can change the title to wideband if you want. then change range low to 10 and range high to 20, click conversion at the bottom then set the equation to what you have above and hit save, it should all read correctly now.

[FXST02]

Try this

[Wade]

thanks for the help guys. ive logged the car today, but still getting the readings with the wideband. doesn't really look right

[Wade]

the heater ground ive ground under the dash to the chassis. I might move it from there. everything else is hooked up as per instructions. linear output to b10, electronic ground and the led ground are grounded through the pcm from memory was a11 and 12 black and red wires. and the positive with 5amp fuse was run up to the cigarette lighter. simulated narrow band I folded up and sealed off as im running 2 bungs off the dump pipe, so only needed to set the 1 narrow band up in the tunes flags

[Wade]

Found the issue. The fuse holder was faulty. No power at the fuse but power going in

[antus]

Thanks for letting us know, glad you found it.