Delco Jeep

[VL400]

Have a look in the ADX for the Decel Enleanment applied to BPW item.

[v6bucket]

It appears that the wideband in the log is reading the same as the LM1 now.
I setup the adx to log "Decel Enleanment applied to BPW" & adjusted the "Decel Enleanment Param - DE delta throttle angle threshold" to .03. The log is included, the info may tell you something.

112 roadtest1.xdl

(1.02 MiB) Downloaded 221 times

OSE_$12P_BLCD_Jeep 6 V112.4.bin

(32 KiB) Downloaded 215 times

[v6bucket]

I might have a solution for the TPS, instead of piggy backing. I have a Toyota tps from a 3s engine which rotates the opposite direction to the GM & Jeep TPS, so it can be mounted on the opposite side of the throttle body. Just got to work out which pins to use, as it's a 4 pin tps.

[festy]

I might have a solution for the TPS, instead of piggy backing. I have a Toyota tps from a 3s engine which rotates the opposite direction to the GM & Jeep TPS, so it can be mounted on the opposite side of the throttle body. Just got to work out which pins to use, as it's a 4 pin tps.

The N13 Pulsar TPS looks identical to the normal commodore type, but rotates in the opposite direction so if the toyota one doesn't work out then it might make a good plan B.

Older Motronic (Bosch) TPSs have 4 pins too - a set of contacts for the closed throttle microswitch and a set of contacts for the WOT microswitch fingers crossed your Toyota one isn't like those...

[Holden202T]

ecotec tps is backwards too.

[v6bucket]

I set the Toyota tps up today, after I made the relevant bracket etc. connected the laptop, the tps voltage is now stable, accept I didn't adjust the switch around enough so had a "TPS Voltage Low" malf & didn't notice it until I got home after short drive, it was at .08 which I lifted to .35 without registering a fault. I still have a very lean condition at 1400rpm, (it doesn't pigroot like it did) even with the fuel table in the 90s. I don't know what to alter to overcome this. I changed the things that VL400 mentioned earlier,(changed the figures either way) but I'm not moving forward.

roadtest4.xdl

(34.53 KiB) Downloaded 217 times

[Dylan]

Possibly a injector setting? That pulse width might need an add on time. Or is it battery voltage dependant?

[v6bucket]

After reading Dylan's reply, I started comparing other bins & found that a bin that I had in 202 Holden 6 had different figures in the tables. So I changed the "Injector Bias vs Battery Voltage" & "Injector bias add-on vs Injector Pulse Width" , now on start up, the engine is much richer even once warmed up. The bin has several other differences which I'll change as well & see if that helps.

[Holden202T]

that's interesting .... is your motor actually a straight 6 or a V6 ? might have been best to start with the V6 calibration ?

[Dylan]

What injectors are you running? Post up a shot of the before and after figures.