Converting 202 to ABS Crank Trigger

[Holden202T]

got it off the net, but it wasn't rusty when i got it, i should have painted it!! has been sitting in the shed for months, i'll be taking it to my mates workshop and using his sand blaster on it though don't you worry!

[VX L67 Getrag]

was there a part number or anything you typed into the NET to find it?

But yeah sand blaster & coat of paint might save it for a few more years!

[Holden202T]

i'm not sure if this was the exact seller but you get the idea

http://stores.ebay.com.au/trigger-wheel ... 34.c0.m322

[VX L67 Getrag]

WOW there's certainly a range of them!

[Holden202T]

yeah i found the one that was going to have the notches above my balancers diameter and went with that, wish it was solid like the picture showed though, would have been easier to put holes in!

[Holden202T]

well had some more progress on this, needed to finish mounting and locating the new trigger in the right spot relative to TDC etc and also needed to re-make the crank trigger bracket in the right spot so that has now all been done!

without precisely timing everything i'm thinking its going to be about 65 degrees reference angle !!

new trigger mount 1.jpg

new trigger mount 2.jpg

Another step closer to a dizzyless 6 coil 202

[VX L67 Getrag]

THAT IS FRIGGEN COOL! Nice work keep us updated!

[Holden202T]

will be once its running on it

[VX L67 Getrag]

I guess that all depends on how hard you push it to how COOL it keeps!!!

[monaro308]

Yeah thats looking good Holden202T

Hmmm a dissyless 308 red motor running 8 coils on the homemade Delco EFI