Guessing plugs on loom

[GH1176]

I picked up a VP engine loom, and as I didn’t get to be the one that removed it I have been guessing which plug go’s where.
I’m down to three, one of which has the same plug as a injector.

[GH1176]

This is the plug

[GH1176]

And the other two single green wires.

[Gareth]

Assuming it’s a V8 loom, the injector type connector should be ignition coil, the green wire with the female barrel connector is the A/C compressor, the green wire with the female blade is temp sender.

[GH1176]

It’s a V6 loom.

[GH1176]

With injector looking plug the white wire is going here to the 6 pin control plug.

[GH1176]

And the brown wire is going here to the 8 pin control plug.

[GH1176]

After stripping more back I found a extra Tacho signal wire which was hidden in the tape.

[Dylan]

Where did you get those documents from?
I'd love to get a hold of them

[GH1176]

Where did you get those documents from?
I'd love to get a hold of them

All off this forum mate.