VS Ecotec, Flooding one bank of cylinders??
-
Holden202T
- Posts: 10394
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: VS Ecotec, Flooding one bank of cylinders??
have you tried another computer ?
No matter what the question is, the answer is always more horsepower! 
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: VS Ecotec, Flooding one bank of cylinders??
Not yet, no...
According to chemistry, alcohol is a solution...
-
antus
- Site Admin
- Posts: 9017
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: VS Ecotec, Flooding one bank of cylinders??
I dont think you will be able to run another computer because the key on - 10 second wait - key off is the kalmaker security doing its thing and the tune will be married to that pcm, another will need a re licence.
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
Re: VS Ecotec, Flooding one bank of cylinders??
Ahhah...!!! Thanks Antus, so it wasn't bullshit then 
Still, do you know of how the original problem may happen in the software?
Still, do you know of how the original problem may happen in the software?
According to chemistry, alcohol is a solution...
Re: VS Ecotec, Flooding one bank of cylinders??
yes holden targeted WOT @ 12.10, they put an adjustment in the Power Enrichment - Trim V's RPM table so it's trims the 12.8 AFR target set, just set them back at 0 and you' get your 12.8 target back.
-
krusty
- Posts: 572
- Joined: Wed Jan 27, 2010 9:45 pm
- cars: VY Calais guzzler, Toyota Corolla almost hybrid
- Location: Melbourne, VIC
Re: VS Ecotec, Flooding one bank of cylinders??
Kalmaker is 1min on, 1 min off for security reset. Could have created a tdm issue there and depending on the type of memcal you're running could be corrupt. Are you running an NM27c010 or DS1245Y?